I an doing a little rear parts:
New springs (TRF "hi-perf?"), Conversion KYD shocks, hoses,
Alpine rear wheel cylinder, Brembo rears, Good adjustable
trailing arm brackets....
I bought my urethanes and steel (TRF, HP154) in 2004.
I took off the TAs and cleaned their. The urethanes the
holes in the middle are not round, there sort of oval now.
Is there anyway to correct this problem or
do I need to replace them? And shoud I get urethane, Prothane
or Nylatron? (I'm not a racer or autox.)
RickO
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|