Hi John,
I have just about the same setup and added Richard's oil separator to
take care of a similar (but not so severe) problem. Others have
suggested placing a roll-pin in the feed line to reduce flow, and a
lot of people think you don't need it at all. I am happy with my
setup though...
Jay
On Sep 10, 2006, at 1:37 PM, John Mitchell wrote:
> Hi everyone, I have a Goodparts GP2 Cam and roller rockers and a
> few days ago installed the external oil feed line as recommended by
> Richard Good. It does seem to quiet the valve clatter, but took it
> on the highway for about an hour today, and after I noticed oil
> dripping down the evaporative canister. The oil level dropped about
> 3/4 quart and I refilled it. Then, on the way back, the motor
> started to stumble on uphill grades. Im assuming I was sucking
> quite a bit of oil through the carbs. Should I get rid of the
> line, or try to cut down the flow some way. Anyone else with
> roller rockers run into this? Thanks for any advice. John
> Mitchell 76 TR6
|