On Thu, 24 Aug 2006 GSFuqua1@aol.com wrote:
> I would be very interested to hear why your machinist thinks a re sleeve is
> a bad idea. Also I have a Austin-Healey that is .060 bored and it does just
> fine.
It's because the machinist doesn't know how to do that job.
A well equipped shop can do a TR6 re-sleeve.
But it's usually cheaper to replace the block. So, based on COST, the
re-sleeve may be impractical.
My take on the initial post is to see if .040 over will work and if not,
go to .060 over.
> Good luck,
>
> Gary Fuqua
> Branson, MO
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
------------------------------------------------------------------------------
|