You use a 1/8" drill bit, and drill them out. You can
replace them with a screw if you wish, but it is better to pick
up a pop rivet tool and some rivets, and rivet it back in.
Rivets come in different sizes, and 1/8" is merely
the most common. They go up from there. If memory serves
(always risky) the washer bottle uses 3/16" (? Shrug).
Vance
------------------------------
1974 Mimosa Yellow Triumph TR6
Cogito Ergo Zoom
(I think, therefore I go fast)
-----Original Message-----
From: Jsut4fun@aol.com [mailto:Jsut4fun@aol.com]
Sent: Wednesday, September 11, 2002 6:43 PM
To: 6pack@autox.team.net
Subject: Washer Fluid Bottle
I am replacing my original washer fluid bottle on my 1976 TR6 and need some
advice on how to remove the fasteners. There is one screw type fastener
that
is not a problem but the other two fasteners are a more permanent type that
look like rivets. I don't want to force these so can someone tell me the
secret to removing them?
Thanks...
|