No, it isn't quite that bad! (I hope!!)
I was in the process of taking the timing cover off and noticed that the
crankshaft would move back and forth! It isn't a lot, so the washers
haven't dropped out completely (yet!), but it's a whole lot more than the
0.006-8in thou. it should be.
Now this is the sticky bit. I'm wanting to get the car back on the road asap
with the fine weather coming, and to buy an engine stand (which I won't need
again) seems a waste, so what I'm wanting to know is, how hard is it to do
the thrust washers with the engine bolted back in the car?
Thanks
Davew
[This message delayed, as it needed manual intervention by the list
administrator. mjb.]
///
/// 2000-register@autox.team.net mailing list
///
|