2000-register
[Top] [All Lists]

Re: Surface corrosion

To: jonmac <jonmac@ndirect.co.uk>
Subject: Re: Surface corrosion
From: David Hill <davhill@cwcom.net>
Date: Fri, 07 May 1999 18:09:45 +0100
Hi John, 

Mine were well clagged with oil as well as some corrosion. I took them
off, cleaned them in a paraffin bath and then dried them with compressed
air. Then, I used a wire brush in a dremel tool and they don't look too
shabby now. 

If you do clean them in situ, you could use paraffin-as I did on the
block before re-lacquering. Just remeber to bung up the holes with
something. 

Cheers, 

Dave Hill

jonmac wrote:
> 
> Guys
> 
> It's injector manifold cleaning time. Mine are looking sorry for themselves
> in terms of discolouration with that powdery substance on the surface,
> though no pitting yet and just very cruddy to look at. Anyone got any
> suggestions of how to clean them up, apart from shooting off to wherever
> with a ten quid note for a bottle of wonder clean? I'd rather do it in situ
> for the simple fact that if I take them off, there's that pain in the bum
> exercise of re-adjusting the butterflies, with airflow meters and all the
> rest. As everything is fine in that regard, why give myself unnecessary
> extra work. Car isn't going to be concours and I doubt anyone is likely to
> want to get underneath to see if I've done the manifold undersides as well.
> 
> John Mac
> 
> Book 1: http://www.toolbox.ndirect.co.uk/triumphbook
> Book 2: http://www.toolbox.ndirect.co.uk/crocus
> Triumph Over Triumph magazine: http://www.cyberware.co.uk/~chips11



<Prev in Thread] Current Thread [Next in Thread>