There is no "proper" speakers that go back there, the factory never put speakers back there (well, maybe in the R&D department). But what fits? I installed some cheapie Radio Shack three way speakers
You will need a two wire bulb holder. One that insulates the bulb base from the fingers. I did this very thing on my 71 but at the moment I can't tell you What I did and what parts I used. But it can
There was a car at VTR last year that was Cream color with Maroon fenders and headlamp pods. Anyone else notice that one? I saw it again at TRA. It drives nice, right Ken? Dave
When I tried the link my computer locked up. But if I go to the home page a click on "Topic of the Month" it comes up fine. Best to go in through the front door, I suppose. Dave
The first thought is booster. Does stepping on the pedal effect the idle speed? Try disconnecting the vacuum hose from the booster (and plug the line to the manifold) and see if that makes a differen
The best test is to substitue another booster, a known good booster, and see if there is any difference. Also check the vacuum hose as someone else suggested. Dave
To find out how much assist the booster gives you remove the hose from the booster and plug it and then drive the car (carefully). The brakes without the booster are quite stiff. But since your car i
Could be the thrust washer. Try this: Press on the clutch with the engine off. Next, get out of the car (with the engine still off) and grab a large screwdriver. Poke the screwdriver between the stee
My first exposure to assembly was at a company that just upgraded from such a system. It used the new 3 1/2 inch floppies and did an assembly in a few minutes. But they still operated with the old 18
Oh, Really? I would not have expected that either. If you get poly bushings be sure to grease them before installation. If you get uprated rubber nevermind. Dave
I have had a few Speedo's do this sort of thing but never a tach... er... rev counter. But in my case a trip to the speedo shop with the fine example of Smiths precision handiwork for some fresh bear
I made a shroud out of sheet rubber and attached it to the outer, stationary portion of the fan. I don't know if your fan has an outer, stationary portion but if it does this may be an option. Trim t