It is near Galena/Westerville. Its 48"x18"x2" - its alot to ask, but would appreciate the help. Thanks! Chris 54 tr2 63 tr4 73 tr6 (in pieces) ** triumphs@autox.team.net ** Archive: http://www.team.n
Don't worry Carl, you're not the only one one this list with crossed wires in their mind.... ** triumphs@autox.team.net ** Archive: http://www.team.net/archive
Hi everyone, I am checking to see if any of you has a Panasport 15 x 5.5 FS series wheel you would like to sell. Panasport has changed to the FZ model and no longer makes the FS series. They are almo
Looking for a high performing padding for the roll bar in my TR6 project. It's supposed to be for my wife - but I think it will likely go to my best buddy who's moving here from the UK this month. Wo
The TR2 has been alot of fun. Wiring is straight, paint is good, We drove over 2500 miles this summer. But.... More smoke blows out of the valve cover and engine vent than out the exhaust.... It's ti
My tr2 had the Triumph badge on the back. Though not original for it, I intended to keep it until i realized it was off center by about an inch. ** triumphs@autox.team.net ** Archive: http://www.team
I've heard chains and gears wear together. With an inch of slack, I'd make sure the gear teeth have enough depth left to do their job. The gears on my tr2 were shallow and quite sharp. I bit the bull
Hi Team, I've looked on the web and in the archives - (Buckeye, RedRiver, 6-pack, other various message boards). Other than wire brushing and blasting - are there any other preventive measures I shou
Had the 63 TR4 out yesterday for a club Chilli run. Was chilly for sure. Top down for the first half of the ride. Got cloudy and went for comfort for the second half. Even at 70 mph the car tracked a
I just rechecked. The shaft is definitely moving in and out of the the steering rack. The joints are solid. Thanks for the response, just the same - someone in the future with a similar problem will
Is anyone else having an issue accessing www.vtr.org? My club site is hosted by VTR and it's down as well. Thanks ** triumphs@autox.team.net ** Archive: http://www.team.net/archive
The original external oil spray system is what kept my TR2 pretty much rust free for all these years. I can't wait to see the improved version! ** triumphs@autox.team.net ** Archive: http://www.team.
I'd look for a used gearbox, swap out the layshaft and run it for a while. I was the grateful recipient of a free TR4 gearbox from a fellow list member who was moving to California. I replaced the la
Of course - your results may vary. The transmission I received was in very good condition and was replaced because of an upgrade to the HVDA 5 speed setup, not because of wear. ** triumphs@autox.team
I do like mcmaster carr. Just placed an order today. Bunch of hardware, rubber bumpers for the tr6 seats and a knob for locking down the spare. ** triumphs@autox.team.net ** Archive: http://www.team.
I have a longdoor TR2 - The original transmission is not an overdrive and was, well overdue for a rebuild. I put a TR4 transmission in the car for now and I'm looking for an old overdrive I can rebui
The seats are done. I had to reweld two nuts and weld a frame member. I paid 45 dollars for foam. I cut it with an electric carving knife. They are back together and looking good, not great. Based on