Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Idle\s+speed\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Idle\s+speed\s*$/: 7 ]

Total 7 documents matching your query.

1. Idle speed (score: 1): Author: "Jack Laird" <jlaird237@cox.net>; Date: Tue, 19 Dec 2006 14:00:58 -0600; She starts and runs too good. I can not get the RPM down to acceptable levels. Throtle adjustment screws clear off. Linkage is adjusted properly. Used WD 40 to test for leaks. Flats at 11 both. Supos; /html/spridgets/2006-12/msg00499.html (6,993 bytes)
2. Re: Idle speed (score: 1): Author: derf <derf247@gmail.com>; Date: Tue, 19 Dec 2006 14:55:40 -0600; I think acceptable levels for Spridgets are around 1kRPM. Although I've gotten them to idle much lower than that, anywhere from 600-1000 should be OK. How's the timing?; /html/spridgets/2006-12/msg00502.html (6,744 bytes)
3. Re: Idle speed (score: 1): Author: "Jack Laird" <jlaird237@cox.net>; Date: Tue, 19 Dec 2006 15:32:53 -0600; Timeing is spot on at 5 degrees BTDC dinamtic but it loves less if the truth were known.; /html/spridgets/2006-12/msg00505.html (6,715 bytes)
4. Re: Idle speed (score: 1): Author: "Jack Laird" <jlaird237@cox.net>; Date: Tue, 19 Dec 2006 15:58:58 -0600; Tomorrow I think I must drop the needles south just a bit, maybe .010 and see if that makes a difference in the idle. I am out of ideas but for that.; /html/spridgets/2006-12/msg00506.html (6,762 bytes)
5. Re: Idle speed (score: 1): Author: derf <derf247@gmail.com>; Date: Tue, 19 Dec 2006 16:00:37 -0600; Always, always, always top off the dashpots when SUs start acting flaky. Then, check for vacuum leaks.; /html/spridgets/2006-12/msg00507.html (6,687 bytes)
6. Re: Idle speed (score: 1): Author: "Paul Asgeirsson" <PAsgeirsson@worldnet.att.net>; Date: Tue, 19 Dec 2006 14:01:56 -0800; Fast idle screw backed off the cam? Throttle and choke cables have some Paul A see; /html/spridgets/2006-12/msg00508.html (7,205 bytes)
7. Re: Idle speed (score: 1): Author: "Jack Laird" <jlaird237@cox.net>; Date: Tue, 19 Dec 2006 16:40:03 -0600; I just checked the needles with a very sharp straight edge and readjusted both for what it is worth. I note that I have a carb leaking down the mixture adjusting bolt again. Those darn cork gaskets I; /html/spridgets/2006-12/msg00510.html (7,118 bytes)

Current List: 1 - 7
Page: [1]