- 1. Re: 20# propane tanks - half full or half empty??? (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Sat, 10 Dec 2005 12:27:49 -0700
- My local fill station charges by the lb. My last top off cost me $3.00. Dave
- /html/shop-talk/2005-12/msg00164.html (9,395 bytes)
- 2. Re: Body work suggestions? (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Tue, 1 Nov 2005 21:06:33 -0700
- shop-talk supported in part by Fat Chance Garage http://fatchancegarage.com I have one of the HF stud welders, but have only used it on one car so far. Quite a few studs were attached on this project
- /html/shop-talk/2005-11/msg00006.html (7,265 bytes)
- 3. Re: Opening a PVC pipe in a hot tub, possible? (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Wed, 3 Aug 2005 21:38:11 -0600
- If I didn't want to do it right, I'd give it a good cleaning, scuffing, by a fillet of an epoxy paste. This should work well, expecially with less than 1 psi. Dave Would be nice to just paint on some
- /html/shop-talk/2005-08/msg00013.html (8,513 bytes)
- 4. Re: Opening a PVC pipe in a hot tub, possible? (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Thu, 4 Aug 2005 21:06:48 -0600
- Trying to open the joint and resealing it is really a poor choice. The right way is to replace the entire section that is leaking. And since this sounds like a very difficult procedure, I honestly w
- /html/shop-talk/2005-08/msg00024.html (9,679 bytes)
- 5. Re: Concrete: Fiber vs mesh (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Tue, 8 Feb 2005 20:46:03 -0700
- Fiber reinforcement actually works quite well especially on a thin (4") slab. The wire mesh reinforcement is extremely difficult to keep at a consistent level during a pour and is often stepped on an
- /html/shop-talk/2005-02/msg00053.html (7,879 bytes)
- 6. Re: welders MIG vs. TIG (score: 1)
- Author: "dave rann" <rdavid205@qwest.net>
- Date: Wed, 29 Dec 2004 22:52:25 -0700
- I must admit to being the same. I have a torch, a mig, and a tig welder. When working on the welding table, with a bit of practice before doing a serious weld, the tig gives nice results, especially
- /html/shop-talk/2004-12/msg00167.html (9,222 bytes)
This search system is powered by
Namazu