Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+How\s+Do\s+You\s+Test\s+a\s+Gas\s+Gauge\s+Sending\s+Unit\?\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+How\s+Do\s+You\s+Test\s+a\s+Gas\s+Gauge\s+Sending\s+Unit\?\s*$/: 5 ]

Total 5 documents matching your query.

1. [oletrucks] How Do You Test a Gas Gauge Sending Unit? (score: 1): Author: Hudson29@aol.com; Date: Sat, 26 Jun 1999 20:18:48 EDT; I just got the gas tank back from Mattson's Radiator after having the ReNew process done and decided to "bench" test the new sending unit purchased during my brief flirtation with Golden State Pickup; /html/oletrucks/1999-06/msg00693.html (9,036 bytes)
2. Re: [oletrucks] How Do You Test a Gas Gauge Sending Unit? (score: 1): Author: "Charles Culver" <sculver@iwl.net>; Date: Sun, 27 Jun 1999 00:03:25 -0700; I'm still wandering the highways and byways wondering at what level my tank is. But I ordered another sending unit, since I finally determined (I hope, at least) that this has to be my problem. When; /html/oletrucks/1999-06/msg00696.html (10,337 bytes)
3. Re: [oletrucks] How Do You Test a Gas Gauge Sending Unit? (score: 1): Author: "Keith" <kvdurand@mail.esc4.com>; Date: Sun, 27 Jun 1999 00:44:44 -0700; Measure the resistance from the screw on the sender to ground. It will vary between 0 and 90 or 0 and 30. Not sure on this sender. Note 0 ohms is full scale deflection of the needle on the ohmmeter.; /html/oletrucks/1999-06/msg00697.html (10,085 bytes)
4. Re: [oletrucks] How Do You Test a Gas Gauge Sending Unit? (score: 1): Author: Grant Galbraith <trks@javanet.com>; Date: Sun, 27 Jun 1999 22:24:25 -0400; It should be a smooth transition from 0 to 30 ohms on an ohmmeter. After driving my truck for 10 K without one I was thrilled at the thought of having a working gas gage on my newly restored truck. I; /html/oletrucks/1999-06/msg00701.html (10,254 bytes)
5. RE: [oletrucks] How Do You Test a Gas Gauge Sending Unit? (score: 1): Author: "Hanlon, Bill" <Bill.Hanlon@COMPAQ.com>; Date: Mon, 28 Jun 1999 06:18:53 -0700; You can't use the volt/ohm meter to verify the gauge, but you can use it to verify the sending unit. 1. Disconnect the wire from the terminal on the tank's sending unit. 2. Connect the meter between; /html/oletrucks/1999-06/msg00708.html (11,544 bytes)

Current List: 1 - 5
Page: [1]