Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Hinges\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Hinges\s*$/: 5 ]

Total 5 documents matching your query.

1. Hinges (score: 1): Author: Bob Nogueira <nogera@prodigy.net>; Date: Thu, 12 Feb 98 22:32:41 -0500; -- [ From: Bob Nogueira * EMC.Ver #3.1a ] -- Okay folks I'm looking for some suggestions here. Shortly I'll be building the doors for the Drophead . One requirement is good hinges. The hinges I have; /html/morgans/1998-02/msg00043.html (7,863 bytes)
2. hinges (score: 1): Author: "L.D. McLaughlin, Jr." <ldmcjr@zebra.net>; Date: Thu, 12 Feb 1998 22:54:12 -0600; It sounds like Bob is becoming a little bit "unhinged"...!! Tony == L.D. McLaughlin, Jr. Daphne, AL, USA ldmcjr@zebra.net http://www.zebra.net/~ldmcjr/; /html/morgans/1998-02/msg00044.html (6,683 bytes)
3. Re: Hinges (score: 1): Author: tjsouz@epix.net; Date: Fri, 13 Feb 1998 08:36:32 -0800; Hi Bob, I think I would try to center the hole by clamping the hinge to the vertical flange of a piece of angle iron. First clamp the angle iron on the drill press table and drill a hole the size of; /html/morgans/1998-02/msg00045.html (7,692 bytes)
4. Re: Hinges (score: 1): Author: FPS3@aol.com; Date: Fri, 13 Feb 1998 15:01:19 EST; I have repined a couple of sets by bolting both halves down and drilling through both at once. Also cured loose hinges by subtle application of a hammer and vise to tighten them. A bit crude sonding; /html/morgans/1998-02/msg00047.html (6,995 bytes)
5. Re: Hinges (score: 1): Author: Oddcarnut@aol.com; Date: Fri, 13 Feb 1998 20:51:06 EST; No you are not the only one. I am certain there is some type of mind meld between Peter & I. Cheers, Ken Payne 63 Plus 4, 61 Mini, 65 Saab, ** Lotish 7; /html/morgans/1998-02/msg00050.html (6,638 bytes)

Current List: 1 - 5
Page: [1]