- 1. Volatage Stabiliser (score: 1)
- Author: "Jack Feldman" <qualitas@millenicom.com>
- Date: Thu, 6 Jun 2002 16:16:30 -0500
- What should be the output voltage of the voltage stabilizer? Has anyone thought of a solid state circuit to take its place. I wonder if a zenner diode would do? I have a gas gauge that has had two n
- /html/mgs/2002-06/msg00161.html (7,111 bytes)
- 2. Re: Volatage Stabiliser (score: 1)
- Author: Max Heim <mvheim@attbi.com>
- Date: Thu, 06 Jun 2002 14:40:29 -0700
- Hmm, a simpler explanation would be a mis-adjusted sender arm. Or if the gauge has any kind of calibration screw... -- Max Heim '66 MGB GHN3L76149 If you're near Mountain View, CA, it's the primer re
- /html/mgs/2002-06/msg00162.html (7,556 bytes)
- 3. Re: Volatage Stabiliser (score: 1)
- Author: Skye Poier <skye@ffwd.cx>
- Date: Fri, 7 Jun 2002 09:46:39 -0700
- It should average 9-10 volts. Yes, and in fact I've had one built for me and its patiently awaiting my new wiring harness :) http://www.mgbexperience.com/electrical/stabilizer.html http://www.mgbexpe
- /html/mgs/2002-06/msg00175.html (7,433 bytes)
- 4. Re: Volatage Stabiliser (score: 1)
- Author: Barney Gaylord <barneymg@ntsource.com>
- Date: Thu, 06 Jun 2002 21:49:07 -0500
- It pulses on and off between full system voltage and zero volts in square wave fashion with a controled average output of about 10 volts. An analog volt meeter will have a jumpy needle. It will just
- /html/mgs/2002-06/msg00196.html (8,065 bytes)
- 5. Re: Volatage Stabiliser (score: 1)
- Author: "Telewest \(PH\)" <paul.hunt1@blueyonder.co.uk>
- Date: Fri, 7 Jun 2002 13:25:17 +0100
- The 'stabiliser' puts out an *average* of about 10v by switching 12 on and off a couple of times a second. If it fails it either causes the gauge to read high or nothing at all. Incidentally, not onl
- /html/mgs/2002-06/msg00197.html (8,305 bytes)
This search system is powered by
Namazu