- 1. MMM Pinion bearings (score: 1)
- Author: "Bob Grunau" <grunau.garage@sympatico.ca>
- Date: Mon, 26 Sep 2005 09:54:55 -0400
- The most recent Fall 2005, page 17, issue of the NAMMM newsletter has a Technical Topic on the conversion of MMM pinion bearings to taperted rollers. Great advice. I decided to check the pinion beari
- /html/mg-mmm/2005-09/msg00012.html (8,182 bytes)
- 2. RE: MMM Pinion bearings (score: 1)
- Author: "Lew Palmer" <lpalmer@roundaboutmanor.com>
- Date: Mon, 26 Sep 2005 18:17:39 -0500
- I seem to remember a discussion a while back on converting to tapered bearings on front stub axles. The theory was that if you do so, it was apparent suicide to not use a spacer between the inner an
- /html/mg-mmm/2005-09/msg00013.html (9,845 bytes)
- 3. RE: MMM Pinion bearings (score: 1)
- Author: "Bob Grunau" <grunau.garage@sympatico.ca>
- Date: Mon, 26 Sep 2005 19:38:36 -0400
- You are absolutely correct. You need the bearing spacer properly shimmed to allow a tight stub axle nut to increase the effective diameter of the stub axles when using tapered roller bearings on an
- /html/mg-mmm/2005-09/msg00014.html (10,174 bytes)
This search system is powered by
Namazu