- 1. Cam shaft bearings (score: 1)
- Author: LGMCAFEE@aol.com
- Date: Fri, 17 Jan 2003 17:15:45 EST
- Scott I remember seeing an article in a book where they took an old cam and cut some slits in the cam with a thin cut off wheel and used that to ream out the bearings that were to tight. In thinking
- /html/land-speed/2003-01/msg00727.html (6,746 bytes)
- 2. Re: Cam shaft bearings (score: 1)
- Author: "Glen Barrett" <speedtimer@charter.net>
- Date: Fri, 17 Jan 2003 15:10:32 -0800
- You might want to make sure the cam does not have a slight bend in it. I ran into that on one of my ford big blocks after a blow up. Cam was bent about .005 but enough to cause a little binding. Too
- /html/land-speed/2003-01/msg00730.html (7,382 bytes)
This search system is powered by
Namazu