- 1. [Healeys] Angle Drive BJ 8 (score: 1)
- Author: "R. Price Lindsay" <price@advocateadvisors.com>
- Date: Fri, 4 Sep 2009 19:58:14 -0500
- I've gone through 3 angle drive in 50 miles. The speedo turns freely. I pulled the cable and noticed the end at the speedo was difficult to pull out and when I did pull it, the end seemed to be "ragg
- /html/healeys/2009-09/msg00088.html (7,268 bytes)
- 2. Re: [Healeys] Angle Drive BJ 8 (score: 1)
- Author: "Michael Salter" <msalter@precisionsportscar.com>
- Date: Fri, 4 Sep 2009 22:15:50 -0400
- An over length inner cable can be the problem, but I have encountered some cases where the speedo odometer section would tighten up after a few miles of operation due to lack of lubrication. Amazingl
- /html/healeys/2009-09/msg00089.html (8,485 bytes)
- 3. Re: [Healeys] Angle Drive BJ 8 (score: 1)
- Author: 63ahbj7 <63ahbj7@comcast.net>
- Date: Fri, 04 Sep 2009 21:52:37 -0500
- Michael's verbage is right-on, Price (he has FASTER But a word of caution here !! << of operation due to lack of lubrication. >> And if this IS the situation disassemble, CLEAN and assemble using ONL
- /html/healeys/2009-09/msg00090.html (6,967 bytes)
- 4. Re: [Healeys] Angle Drive BJ 8 (score: 1)
- Author: Oudesluys <coudesluijs@chello.nl>
- Date: Sat, 05 Sep 2009 11:25:31 +0200
- Good advise, although Smiths in the old days advised lithium grease used sparingly. I have always used EP90 copiously as I did not know any better untill recently. Luckily I never had any mishaps on
- /html/healeys/2009-09/msg00093.html (8,918 bytes)
This search system is powered by
Namazu