- 1. Intake Manifold Torque (score: 1)
- Author: SteveMines@verdugohillshospital.org
- Date: Mon, 23 Jul 2001 09:37:19 -0700
- Could someone please tell me the proper foot pounds to torque the intake manifold bolts. Also, is some type gasket sealer recommended along with the new intake gaskets? I am awaiting the arrival of
- /html/buick-rover-v8/2001-07/msg00042.html (7,010 bytes)
- 2. Re: Intake Manifold Torque (score: 1)
- Author: lmg@gomog.com
- Date: Mon, 23 Jul 2001 16:26:52 -0400
- Inlet manifold to cylinder heads -3/8" U.N.C bolt - 40Nm - 30ftlbs Lorne /// /// buick-rover-v8@autox.team.net mailing list ///
- /html/buick-rover-v8/2001-07/msg00043.html (7,107 bytes)
- 3. Re: Intake Manifold Torque (score: 1)
- Author: jon <jonaxt@pacifier.com>
- Date: Mon, 23 Jul 2001 13:44:31 -0700
- According to my factory Buick manual, the torque on those 3/8-16 is 25 to 30 foot pounds. Quoting "6. Tighten all manifold to cylinder head bolts a little at a time until all are snug, then torque to
- /html/buick-rover-v8/2001-07/msg00044.html (7,674 bytes)
- 4. Re: Intake Manifold Torque (score: 1)
- Author: Wake074@aol.com
- Date: Mon, 23 Jul 2001 19:11:22 EDT
- While others have already answered your question, if you take a look at my website, you can find scans of the engine specs pages from my Buick manual. Go to: http://members.aol.com/wake074/mgbv8.html
- /html/buick-rover-v8/2001-07/msg00045.html (7,434 bytes)
- 5. Re: Intake Manifold Torque (score: 1)
- Author: Ian Crocker <ian@btcase.bt.co.uk>
- Date: Tue, 24 Jul 2001 13:14:55 +0100 (BST)
- Book says 25-30ftlbs but I have had problems and use less - plus you can't usually get a torque wrench on some of them. The latest foam covered gasket doesn't use any sealant. Regards, Ian /// /// b
- /html/buick-rover-v8/2001-07/msg00046.html (7,224 bytes)
This search system is powered by
Namazu