- 1. DIY on Speedos? (score: 1)
- Author: Sean OBrien <saob_100@yahoo.com>
- Date: Sat, 17 Sep 2005 19:32:08 -0700 (PDT)
- Dear Listers, Today, I took my new Dan Master's Electrical Maintenence Handbood to the garage and repaired 3 items that were on my Things-To-Do list. The book was great. However, one of the items was
- /html/6pack/2005-09/msg00248.html (8,005 bytes)
- 2. Re: DIY on Speedos? (score: 1)
- Author: "Jeff Fetner" <fetnerj001@hawaii.rr.com>
- Date: Sat, 17 Sep 2005 21:28:31 -1000
- It's not too hard to do, Sean. You'll need to take the chrome ring and glass off, then unscrew the two screws at the back of the speedo. This will allow the whole mechanism to come out through the fr
- /html/6pack/2005-09/msg00252.html (9,510 bytes)
- 3. Re: DIY on Speedos? (score: 1)
- Author: "Dwayne Cooper" <dc_bruin@hotmail.com>
- Date: Sun, 18 Sep 2005 19:34:43 -0700
- A note of caution is in order here -- the plastic needle has probably become very brittle due to years of sun exposure. Funny story (TR6 Funny -- some would be reduced to tears): I had my tach apart
- /html/6pack/2005-09/msg00267.html (7,426 bytes)
- 4. FW: DIY on Speedos? (score: 1)
- Author: "Foster, Stan" <stan.foster@hp.com>
- Date: Sun, 18 Sep 2005 22:49:09 -0400
- 3rd and final attempt at posting this reply. Sean, the speedo is fairly straightforward to dismantle but you do need to take care. Once you have undone the speedo drive and removed the two nuts that
- /html/6pack/2005-09/msg00268.html (9,100 bytes)
- 5. RE: DIY on Speedos? (score: 1)
- Author: "Saul W. Adelman" <sadelman@woh.rr.com>
- Date: Mon, 19 Sep 2005 06:33:24 -0400
- When I glued my bezel on to the speedo I used a little bit of clear silicone on the end of a tooth pick. I figured that it would handle the vibration better. The super glues may flash and leave a whi
- /html/6pack/2005-09/msg00270.html (6,933 bytes)
This search system is powered by
Namazu