My bad. I should read before I comment. I see you did balance the
driveshaft.
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey@charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: vintage-race-bounces@autox.team.net
[mailto:vintage-race-bounces@autox.team.net] On Behalf Of Tracy Drummond
Sent: Thursday, January 07, 2010 9:20 AM
To: 'John Donohoe'; lotus@se7ens.net; vintage-race@autox.team.net
Subject: Re: [Vintage-race] Driveline angles and vibration? (General, but in
my Lotus Seven)
John,
Maybe pretty simple but have you balanced your driveshaft?
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey@charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: vintage-race-bounces@autox.team.net
[mailto:vintage-race-bounces@autox.team.net] On Behalf Of John Donohoe
Sent: Thursday, January 07, 2010 8:06 AM
To: lotus@se7ens.net; vintage-race@autox.team.net
Subject: [Vintage-race] Driveline angles and vibration? (General, but in my
Lotus Seven)
For years I've struggled with a vibration in the Seven that seems to come
and
go at various speeds, and is the same regardless of wheels (I've run 2 types
of steel and one set of cast aluminum wheels all resulting in the same
vibration). I balanced the driveshaft, and checked the u-joints, all good.
Today I stumbled across this instructional booklet on drivetrain
alignment: http://www.iedls.com/IEDL_PTS_LGL_091008_Secure.pdf and now I
wonder about checking the alignment between my engine and differential
pinion
shaft. When I got the Seven, the the BMC smoothcase gearbox was attached to
a
Sprite mount, which was bolted straight to the aluminum floor of the
transmission tunnel with a single large bolt! This also resulted in the
bellhousing clunking against the lower, curved firewall frame tube over
every
bump, and yes, the vibration was horrible on the 6 inch wide, custom Lotus
steel wheels that were on the car when I bought it. One of my first
'modifications back to original' was to make a crude aluminum bracket to
raise the gearbox and spread the load on the tunnel floor. With hindsight,
it
seems the vibration is less now, but till present. Did I partly fix the
problem by slightly changing the relative angles of engine and pinion shaft?
Has anyone fussed with this variable? One other detail is that there is a
pronounced angle of the engine/transmission itself--the engine is not
parallel
to the centerline of the car... could this be another cause? Input
appreciated
as I prepare to pull the engine and will have the opportunity to make
adjustments! Cheers, John Donohoe SimpleSevens
You are subscribed as bighealey@charter.net
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
You are subscribed as bighealey@charter.net
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
|