Thanks for the report....I am about to install essentially the same system....
with support from Tony Drews.....thanks to, Tony, as well.
Joe Alexander
> I'd like to thank everyone who gave me suggestions and shared their
> positive
> and negative experiences with various pumps, regulators, etc. in response
> to
> my question of a few weeks back. You may remember that I posted about a
> final negative experience with a FACET cube pump and asked for input on a
> replacement pump and regulator setup.
>
> In the end I installed the Holley Blue pump and Holley low pressure (1-4
> psi) regulator and pulled larger lines--3/8 versus 5/16--from the cell up
> to the
> regulator and through a Y-divider (with fuel pressure gauge mounted on it),
> then 5/16 up to the HS6's. After completing plumbing and wiring today I
> fired it off and adjusted the regulator to 3 psi at fast idle, then
> repeatedly
> revved to 5K. The fuel pressure stayed constant, the EGT guages looked
> even
> and there was no overflow from the bowls so I think I am good to go, or at
> least start the next event.
>
> Best--Michael Oritt
> Elva Courier
>
</HTML>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
|