Part has to be baked at moderate temperature for a couple of hours, and
most important, the process has to begin as soon as it's out of the plating
tank. If the part is allowed to sit for just 24 hours without treatment,
the part will be compromised.
Does anyone happen to have a metallurgy specification for torsion bars?
Mike Frank
At 08:20 AM 11/14/02, lwdent wrote:
>Suffice it to say in initials a slow heat for a number of hours to
>remove any hydrogen trapped under the plating, as I recall.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/vintage-race
|