I am setting up a Quaife LS in an MGA rear end. None of the manuals that I
have looked at provide the pinion zero depth spec. They just refer to a
reference block for the "A", "B" or "C" distances. Since I do not have that
special block I am wondering if anyone out there has the actual dimensions.
I am also looking for the ring carrier bearing shims. The Moss catalog list
them as "not available". I believe they come in 2 thou increments up to
about 12 thou.
If anyone knows where a good procedure for setting this up is published I
would be greatly appreciate the pointer.
Thanks,
Phil Roettjer
Lotus 6 (with MGA rear end)
/// vintage-race@autox.team.net mailing list
/// or go to http://www.team.net/cgi-bin/majorcool
///
|