Greetings!
The Cortina GT rally car project is in a zillion pieces in the workshop
this week and the shell is completely stripped as I'm going over it doing
the wee bit of patching it needs, dinging out the dents and taking all the
iccy paint off. While it's gutted it's a good time to put the roll bar in
but since it's exactly the same amount of work to do it right as do it
wrong and there's a chance it might eventually find its way down to the US
for competition, I figger I might as well build an SCCA spec roll bar.
Can anyone tell me what diameter, wall thickness and material SCCA want for
a rear bar? I'll leave the front part out for now, if it's needed in the
future we can always do that.
Thanks!
--Marcel Chichak chichm@planet.eon.net
Edmonton Alberta Canada, eh?
Peek into my world: www.planet.eon.net/~chichm
|