I'm looking at better solution for hinging my new Vixen bonnet using
spherical rod ends or rose joints. The thread in the DavidGerald
fitted frame is 3/8 UNF and the std for rose joints is UNF as
its an American aircraft spec. So two, 3/8 UNF male rose joints
screw into the frame and then mount a 3/8 bit of rod on the brackets
holding the water radiator. The question is: how to provide fore and
aft adjustment?
Ideas anyone?
Regards,
John
--
Dr John Upham, The UKMotorSport Index,
http://www.ukmotorsport.com/, webmaster@ukmotorsport.com,
Voice: +44 (0) 976 634 053 (W), Voice: +44 (0) 125 287 2551 (H),
Voice: +44 (0) 976 634 053 (M)
Registered address: Reid House, Mill Hall, Cuckfield, West Sussex RH17
5HX
Registered number: 3445711
|