If it was snug to get the corners on then it sounds like the correct one.
Once the rubber is on the glass you place the installation cord (I use
clothes line string) into the slot the the body flange goes into. Place
the chrome surround into it's slot, lube the seal (do not use
dish-washing soap as it has a high salt content)and place the bottom
edge onto the body flange. Make sure it is pushed well down onto the
flange. Use the cord to work the two lower corners on and the work your
way up. I like to finish in the middle of the top.
If you are having difficulty getting the upper corners in check that the
lower flange is all the way down. The rubber seal should not be too
difficult to install if placed correctly.
Edward Hamer
Petaluma CA
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|