What Jerry said. I've had the same experience - different thicknesses.
- Tony Drews
On 6/29/2020 4:08 PM, Jerry Van Vlack wrote:
> You should measure the liner protrusion with one or the other
> installed. In my case I found the figure 8's were different thickness.
> Use the figure 8's that result in your liner protrusion being within
> spec.
> JVV
>
> -----Original Message----- From: bill beecher
> Sent: Monday, June 29, 2020 4:53 PM
> To: Dave Ranteer
> Subject: [TR] Copper v Steel Fig â??8â??
>
> Just received my 87mm pistons and liners from TRF, the package
> included steel figure eight gaskets, my gasket kit from TRF included
> copper ones. Is there any consensus as to which is preferred?
> Thanks,
> Bill B
> TS30800L
>
> Serenity Now......
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs
> http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/jerryvv@roadrunner.com
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs
> http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/tony@tonydrews.com
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|