Hi Paul,
I used a highly recommended automotive machine shop, J&M Machine in
Southborough MA. All I had to do was tell them what I wanted done and they did
the calculations and executed the machining. They did the block, rods, pistons,
bearings, decked the block and valves. They were not cheap, but having a new
engine go south is a lot more expensive.
Best,
Bob
> On Sep 6, 2019, at 7:03 PM, Paul Dorsey <dorpaul1@gmail.com> wrote:
>
> I am new to the TR three however, I need to do a head job on my TR three
> that is not running. I wonder if you happen to know where I might find
> recommendations for the head so that I Can make the machine shop aware of
> alterations for current conditions in fact I donâ??t know even what to ask
> the list.
>
> Thanks Paul Dorsey Athens Georgia
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|