--===============0620174995742964838==
--00000000000004019e057f63d949
I have what appears to be a flat / unwarped head. measured with a
straight edge in an X pattern across the head. The only problem is there
is a slight impression of the fire ring from the gasket on one end. Does
this impression need to go? Implying I need the head skimmed?
This is for a Stag which is similar to that of a TR7
Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
--00000000000004019e057f63d949
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">=C2=A0 I have what appears to be a flat / unwarped head. m=
easured with a straight edge=C2=A0 in an X pattern across the head. The onl=
y problem is there is a slight impression of the fire ring from the gasket =
on one end. Does this impression need to go? Implying I need the head skimm=
ed?=C2=A0<div>This is for a Stag which is similar to that of a TR7</div><di=
v><br></div><div>Sujit=C2=A0<br clear=3D"all"><div><br></div>-- <br><div di=
r=3D"ltr" class=3D"gmail_signature" data-smartmail=3D"gmail_signature"><div=
dir=3D"ltr"><div>Sujit Roy<br>Cupertino, California</div><div><br><a href=
=3D"https://triumphstagblog.wordpress.com/"; target=3D"_blank">https://trium=
phstagblog.wordpress.com/</a><br><br></div></div></div></div></div>
--00000000000004019e057f63d949--
--===============0620174995742964838==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
--===============0620174995742964838==--
|