Good question, I always used the same values. Maybe that was the right thing
to do but I am no engineer.
Bill B
Sent from my Handspring Treo
On Aug 10, 2018, at 11:17 AM, Sujit Roy <triumphstag at gmail.com> wrote:
Due to tight space, I can't put a socket on the end of a torque wrench, but I
can put a small Craftsman crow foot on the end.
If I do this, by what factor should I add or remove from the specified torque
for a bolt?
I'm working on a Triumph gearbox with OD.
Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
** triumphs at autox.team.net **
Archive: http://www.team.net/archive
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180810/a625a1ad/attachment.html>
|