Marcel - if the AXLE is actually moving out, you may have inner axles that have
been modified. The stock setup uses a shoulder on the differential side of the
axle to prevent the axle "walking" but I have seen folks turn the axles down to
remove the bearing and seal so-as to replace the seal. This usually happens
when you can't get the drive flange off the axle stub but you are trying to fix
the leaky axle stub seals.
If the DIFF is walking around - check the mounts. There's probably a broken
mount pin or pin mounting. This is very common on IRS cars.
Regards,Bob Lang
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180713/343a2019/attachment.html>
|