The inner axle shaft (right side) has moved out of the axle house by as much as
12mm, so far that a lot of oil has leaked after a race.
The ball bearing has slided inwards on the axle shaft by the same amount
(retained by the oil seal housing). Has anyone experienced this? Before? I
noticed these bearings had moved a little, but never more than 3mm. In fact,
nothing does prevent the bearing of sliding on the axle shaft, except the
interference.
Does someone know a fix? Loctiting the bearing on the axle shaft? Machining a
groove for a circlip?
Marcel.
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180713/38a2a38d/attachment.html>
|