What did you use to polish the inside? Looks nice.
Bill B
Sent from my Apple II+
On May 27, 2018, at 8:15 PM, David Templeton <davidt at opentext.com> wrote:
First off thanks as always for the advice, I got a number of suggestions and it
seems a bit of elbow grease and emery paper was the recommended course of
action. It was suggested to make sure of the contact point to use a blue
indicator, well it is $9usd and $50cdn. So needed another solution. Reading
other posts on different sites, it was suggested to use a fat sharpie to colour
the metal then make it the parts rub. Then the contact point showed up. Well,
after about 2hrs of sanding and checking I got it to slide cleanly. After carb
cleaner and polishing of the piston and pot and voila finally reinstalled?.
Those pistons go thunk now
David
<20180527_122247_LI.JPG>
<20180527_132112.jpg>
<20180527_132832.jpg>
** triumphs at autox.team.net **
Archive: http://www.team.net/archive
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/triumphs/attachments/20180527/fd5c0101/attachment.html>
|