Larry's step 15 to ensure the pump get's primed is key. Saves lots of
aggravation on the test stand.
You can't really know what is going on without a pressure gauge, I got
mine from Jay Holekamp. Works just fine.
jholekamp at sbcglobal.net
http://www.geocities.ws/jholekamp/
h
On 2018-03-07 15:41, Larry Young via Fot wrote:
>
> One problem I have frequently had is that the unit will not pressure
> up after I put oil in it.? I've always thought it was because of all
> the air in the lines. I developed an assembly method to make sure I
> got oil pumped at each step. You could also use it as a
> troubleshooting method. You might check it out starting at Step 15 in
> http://vintagetriumphregister.org/maintain/TransRebuild/OverDriveA02.pdf.
> Another trick I've heard is to put Vaseline jelly in the pump to help
> it get started.
|