triumphs
[Top] [All Lists]

Re: [TR] TR3 seat tracks etc

To: "dave@ranteer.com" <dave@ranteer.com>
Subject: Re: [TR] TR3 seat tracks etc
From: Wbeech <wbeech@flash.net>
Date: Fri, 11 Jul 2014 10:06:03 -0500
Cc: "triumphs@autox.team.net" <triumphs@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
References: <20140711075203.eacca00412c4e976446146f9b5e47255.e620ec1ee7.mailapi@mailapi06.secureserver.net>
I used washers and lock washers for the seats, just lock washers for the
tracks on mine.  ISTR 1/4-28x3/4" did the job.

Doors take 3/4" #4 stainless slotted  sheet metal screw and cup washer.  Take
great care with your drill going though the panel, if you have a small punch
that would be good.


Sent from mobile Bill

On Jul 11, 2014, at 9:52 AM, dave@ranteer.com wrote:

Getting ready to install the full interior kit on a 57 smallmouth.  The
interior kit was ordered from TRF years ago.  There is no hardware (nuts,
bolts, and screws).

It looks to me, from the moss catalog, that I need 16  of 323-580 for the
doors.

Then I need 8 bolts for the seat tracks. Can anyone tell me the correct
size/length and if I should put in washers or lock washers?  These don't show
so I'm looking for best practice here.

I can easily measure the size but I'm particularly concerned about length and
if I should use washers.  The moss pages are not helpful.

Thank you!

** triumphs@autox.team.net **

Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>