Bob,
Sorry, I wasn't clear. I have the complete original door with the aluminium
base and hinge with the very little screws securing the vinyl covered wood
face. Just want to either replace the face so it can be coated or the
entire unit.
Thanks,
Bill
-----Original Message-----
From: Bob Labuz [mailto:yellowtr@adelphia.net]
Sent: Thursday, January 09, 2014 10:55 AM
To: wbeech@flash.net; triumphs@autox.team.net
Subject: Re: [TR] Dash Painting/P.Coating
Bill,
The original cubby box door base is aluminium not wood. The previous owner
must have lost the original. I am not sure if any of the suppliers can get
you a replacement. Should be not too hard to make a new one. The vinyl
covered wood may be original but is supposed to attach to the aluminium base
with very small counter-sunk wood screws. Just long enough to secure to the
wood but not penetrate.
The problem I see is the aluminium base is attached to the dash with a long
chrome plated hinge which is riveted to the base. Not surer how you could
duplicate this hinge unless your door is currently hinged with the original
removed from the aluminium base.
Maybe someone has a spare they could sell you.
No experience with PC so others might chime in. I just rattle canned mine
with rustoleum.
Bob
On 01/09/2014 11:10 AM, wbeech@flash.net wrote:
> I know I am not the first to think of trying this so I would again
> implore the List for BTDT wisdom.
>
> I am thinking of either painting or powder coating the dash on my
> current
> TR3 project, but curious as to what others have done with the cubby
> box door. So far, my only solution is making an aluminium panel to
> replace the vinyl covered wood that is currently there.
>
> All thoughts and pictures appreciated,
>
> Cheers,
> Bill
>
> Bill Beecher
> '58 TR3A TS/30766L "Tarbaby"
> '62 TR3B TCF/2549L " Aunt B" (in rehab)
> <http://www.triumphowners.com/1566> www.triumphowners.com/1566
> '68 Land Rover Series IIa 88" "The Beast"
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|