| To: | ''Triumphs'' <triumphs@autox.team.net>, cfmtr3a@verizon.net |
|---|---|
| Subject: | Re: [TR] TR3A Headlamp question |
| From: | Randall <tr3driver@ca.rr.com> |
| Date: | Wed, 16 Oct 2013 18:51:05 +0000 |
| Authentication-results: | cdptpa-omtalb.mail.rr.com smtp.user=tr3driver@ca.rr.com; auth=pass (LOGIN) a=IkcTkHD0fZMA:10 a=ayC55rCoAAAA:8 a=KGjhK52YXX0A:10 a=1zR8YkKZYlQA:10 a=o1OHuDzbAAAA:8 a=Puli6KL7RdGcy4KvfjQA:9 a=QEXdDO2ut3YA:10 a=ILCZio5HsAgA:10 a=MovjwzxRu9sA:10 a=6A/OvQor+YwyjOO4FWhaEA==:117 |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | triumphs@autox.team.net |
| Sensitivity: | Normal |
---- CFM-TR <cfmtr3a@verizon.net> wrote: > I understand how the outer trim ring attaches but my question is should the > clip at the bottom be closed or open. In other words, is it open enough for > the tab to push through and latch or is it closed and the tab has to be > pushed below the clip and into the opening? I could be mistaken, but I believe the clip is supposed to be closed (or nearly so), and the tab spreads the legs of the (spring) clip as it gets pushed into place. But I've always had to use the back end of the removal tool to push the tabs through, so maybe I've been doing it wrong all these years. Randall ** triumphs@autox.team.net ** Archive: http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TR] Roll bar and tonneau., Chris Simo |
|---|---|
| Next by Date: | Re: [TR] Tr4 door seals, Carl Sereda |
| Previous by Thread: | [TR] TR3A Headlamp question, CFM-TR |
| Next by Thread: | Re: [TR] TR3A Headlamp question, CFM-TR |
| Indexes: | [Date] [Thread] [Top] [All Lists] |