The thought of attaching that set-up over new paint sounds scary. At least
with the dzus type, you were able to slide the stanchions over the plates....
Thanks for the feedback!
-----Original Message-----
From: Carl TR [mailto:cfmtr3a@verizon.net]
Sent: Friday, May 24, 2013 3:33 PM
To: triumphs@autox.team.net
Cc: wbeech@flash.net; auprichard@uprichard.net
Subject: Re: Re: [TR] TR3 stanchions and plates
TS81802 came with plates that were between the stanchions and body. similar
to the Dzus ones but without the cut-out for the springythingamajig. There
was one extra in the parts bin - can't remember if it is left or right side.
They do have only the two holes.
Carl
1961 TR3A - TS81802LO
mysite.verizon.net/cfmtr3a
Tampa, Florida
On 05/24/13, WBEECH wrote:
I don't have any plates for TCF2549, stanchions bolt directly to the body. I
imagine this was the brainchild of some Coventry cost-cutter.
Bill
Sent from my iPhone
On May 24, 2013, at 1:50 PM, "Andrew Uprichard" <auprichard@uprichard.net>
wrote:
> List:
>
>
>
> How are you expected to hold the stanchion plates in place for the
> later
> (non-dzus) windshields? The dzus plates have three holes for securing
> screws to the body, but the later ones have just two for the large
> bolts which go through the stanchions. Any help appreciated. Thanks!
>
> Andrew Uprichard
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|