No, do not try to drill the glass.
It will solve you problem in that you will have to remove the frame to replace
the windshield.
Bill
Sent from my iPhone
On Oct 19, 2012, at 12:18 PM, "Andrew Uprichard" <auprichard@uprichard.net>
wrote:
Thanks as always to Randall. Solves my problem for the one hole not obscured
by the windscreen glass. The other hole, unfortunately, is. Before I go
with
the JB weld option, is there any way of drilling through glass without
cracking it? The pop-rivet nut insert isn't going to work as the glass is
too
close to the frame.
Before you ask, the glass can't be removed from the frame. It's a long
story.....
Andrew Uprichard
-----Original Message-----
From: Randall [mailto:tr3driver@ca.rr.com]
Sent: Thursday, October 18, 2012 4:24 PM
To: triumphs@autox.team.net; Andrew Uprichard
Subject: Re: [TR] Stupid, stupid
---- Andrew Uprichard <auprichard@uprichard.net> wrote:
> I am in the middle of a small-mouth restoration and recently had the
> stanchions and windscreen frame re-chromed. Went to install the nine
> small tenax fasteners and realized that a previous owner had drilled
> out two of the holes.
There is a special Tenax stud that was originally used only on aluminum
frames. It doesn't thread into the frame at all, instead it passes all the
way through and has a slotted flathead "nut" that comes in from the other
side. Only noticeable if you look for it, and not objectionable then, IMO.
I
haven't tried it yet, but I am planning to use one of them to 'repair' a
stripped hole in my original windshield frame.
TRF had the studs reproduced. I don't recall the PN offhand, but it's in the
SPC. When you go to drill the frame, use a fine stone to remove the rake at
the tip of the drill (basically dull it a bit) so it doesn't dig into the
soft
brass under the chrome. It might be wise to use a Dremel and a small
abrasive
burr to cut through the chrome layer, to avoid the possibility of peeling it
off around the hole.
I will also be using a stop collar on the drill bit, to limit depth and
hopefully keep it from hitting the glass, but I assume you won't have that
problem.
Randall
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net
|