Did the same thing, had to use the real narrow 1/2 inch? And cut the bottom
off the front one.
On May 30, 2012, at 11:02 AM, Gary Nafziger wrote:
> I've installed a TR-4A exhaust manifold on my tr-3 and therefor had to use
a
> different intake manifold which pushed the carbs out toward the inner
fender
> at least another inch. I'll need to fit different air filters and believe
> I've read some where that the K and N tapered ones might fit without
> "adjusting" the inner fender.LOL Does anyone have experience with this?
>
> I
> also was curious about how filters are measured. Moss sells tapered K and
N's
> in sizes 1 1/2" as well as 1 and 3/4. The intake hole in my carb is 1 and
> 5/8. Am I measuring the right thing?
>
>
> thanks!
>
> gary n.
>
Bill Pugh
1957 TR3 "Casper"
TS16765L
Wallace, CA
anabil007 at comcast.net
|