Hello List:
Trying for a better fit on some of my body panels on my '2. I did have
the body off and fitted a new mounting kit. Had the usual fiddling
problems with door fit & some seams but now stumped on the rear trunk
area. When fitting the new body mount kit, I made sure that the rear
bumper bolts would go through the frame and used this as a reference
point. However, my trunk opening seems to have 'shrunk', with the trunk
lid sitting very high right in the center by the lock. Not even close to
being able to close the lid, even without the weather stripping.
Wondering if I cranked down on the rear most body mounts to see if this
might open the trunk opening and allow the lid to fit a bit better. Any
hints on aligning this opening, especially after the rear bumper long
bolts are installed?
Thanks for any help with this one.
Angelo Graham
|