Subject: | [TR] Lucas Batt Cap screws |
---|---|
From: | tr3driver at ca.rr.com (Randall) |
Date: | Thu, 22 Mar 2012 11:43:01 -0700 |
References: | <04AC6119A9D849139B5770729663C6D1@bboffice> <1332437316.44105.YahooMailNeo@web29404.mail.ird.yahoo.com> <1332437965.28889.YahooMailNeo@web120201.mail.ne1.yahoo.com> |
> the post is not pre drilled use a #29 drill (0.136") or try a 1/8" > drill. lead > post is quite soft so you may be OK with the smaller dia drill. Probably best to use an old somewhat dull drill bit if you have one. If not, keep a good hold on the drill motor as the bit will likely try to dig in and twist sideways. -- Randall |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TR] Lucas Batt Cap screws, Frank Fisher |
---|---|
Next by Date: | [TR] Lucas Batt Cap screws, Dave1massey at cs.com |
Previous by Thread: | [TR] Lucas Batt Cap screws, Frank Fisher |
Next by Thread: | [TR] Lucas Batt Cap screws, Dave1massey at cs.com |
Indexes: | [Date] [Thread] [Top] [All Lists] |