Anyone have any experience with the stud spacing on TR3 and TR3A front badges?
My 57TR3 came with an incorrect front badge (no T-R-I-U-M-P-H lettering on the
lower edge). While doing some body/paint work this past winter, I obtained a
new correct badge (with T-R-I-U-M-P-H lettering across the bottom of the
badge). When I went to switch over the emblems, I discovered the one without
lettering has the studs spaced 2 1/2" on center but the replacement badge has
the studs spaced 2 5/8" on center.
Does anyone have experience with the dimensions? Is the problem potentially
with the repro or the holes in the front apron? TIA for your feedback.
Keith R. Stewart
75 Camden Road
London, Ontario
N5X 2K2
Home: (519) 660-1916
E-Mail: keithstewart at execulink.com
|