Jeremiah,
The method I usually use is to just hit the button on the starter solenoid and
let the starter do the work. Or, I put pressure on t he fan belt with one hand
and turn t he engine over by turning the fan with the other hand. You could
also jack up one rear wheel, p ut the car in 4th andB rotate B t he wheel to
turn over the engine. Or maybe you could shim t he motor mounts so that the
crank hole lines up .B Removing the spark plugs makes it a lot easier, but I
generally don'tB do that - I have an aversion to removing all the spark plugs
at t he same time.
Bob
----- Original Message -----
From: "Jeremiah Curry" <jeremiah@curryclan.net>
To: triumphs@autox.team.net
Sent: Tuesday, January 3, 2012 2:10:33 PM
Subject: [TR] TR3 how to set valve clearance with the front apron on.
Hi Guys,
B
Probably an easy question
B
B I just replaced the headgasket in my TR3 and figured that since I removed
the rockers, I should re-set the clearance. B Last time I did that, the front
apron was off and I just turned the engine over using the handcrank. B Now I
can't do that (hole in radiator/grill don't line up, probably because I have
a TR3a radiator on a TR3) B How do you turn the engine the right amount to
get each cylinder TDC?
B
Thanks,
Jeremiah
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/kinderlehrer@comcast.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|