Carl,
It has been so long since I did the 3 I cant remember but on the 4 and
6, you cannot put it all together first and then install it.
On the 4 and 6 you have to do it by sections working with the inspection
covers off to gain access to both wheel boxes. Real PITA on both 4 and
6. Messy since everything is greased. Lots of colorful language was
heard in the garage during installation.
No measurements available sorry.
Bob
On 12/05/2011 01:25 PM, Carl TR wrote:
> Project is moving along - slowly oh so slowly..
>
> What is the best way to install the Wiper Rack and Wheel boxes on a TR3A?
> Are there any BTDT issues.
>
> 1) Put it all together first (including grease), or
> 2) Install in sections. - Install the tubing and boxes then the rack
> (Grease as I go)
> 3) Demister vents installed or out (they are in but if it will make it
> a lot easier - not a biggie to take them back out).
> 4) I have the tubing from several - There are slight variations in the
> lengths. I can figure out the center and short end but does anyone have the
> measurement for the curved one - from wiper motor connection to the box?
>
> Thanks
> Carl
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|