> I'm wondering if a comparable weight
> of plastic could
> be used to fabricate.
Plastic should do fine, but try to get something with a fairly high melting
point. The inside of the motor can get pretty warm if it runs for a long
time.
If you know someone locally that dabbles in electronics, they might have a
piece of bare printed circuit board that would do nicely. The original was
phenolic (the brown stuff), but the green fiberglass stuff would work just
as well.
-- Randall
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|