I am getting ready to install a new B&B Clutch and Gunst TO Bearing in my '70
TR6. One question I have that probably seems obvious, but the language in the
instructions is slightly off. The two sliding blocks are to go on the thrust
pins with the red colored surface facing up. Am I correct in translating this
to the sliding blocks go on the Release Fork Pins? This would mean the square
sliding blocks ride in the sleave grove and not the actual pins. If so, just
out of curiosity, why this needed modification? TIA
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3A
|