All,
I am in the process of covering the seats and have a question.
When I set the back foam into the seat it is proud at the top by roughly 3-4
inches.
The top of the cover obviously needs to be flush with the top of the frame.
Can anyone advise me on the best procedure to use to make this happen?
My guess is to place it over the frame, then pull down until it is flush and
clip it down, then start stretching and clipping the sides?
Cheers,
Guy D. Huggins
1965 Triumph TR4A
CTC 63569LO
Online project diary at http://www.genfiniti.com/triumph
|