Thanks. It's for a Stag. I want to swap out the electrical one for a bulb
type. Anyone know what is the typical thread used for the bit that goes in
the block?
They have this listed.
* *Supplied with 6' 6" capillary. 3/8" BSP female connection. 5/8" UNF
male thread also available.
Sujit
On Thu, Jul 7, 2011 at 10:34 PM, Bill <anabil007 at comcast.net> wrote:
> Not sure what Triumph you have, but these are Smiths gauges ...
>
>
> http://www.gaugeguys.com/**Smiths/classic.htm<http://www.gaugeguys.com/Smiths/classic.htm>
>
>
>
> I'd like a kit if possible where the temp sender part can bolt into the
>> block/head
>>
>> Sujit
>>
>> --
>> Sujit Roy, Realtor
>> Keller Williams Realty, Cupertino, CA
>> (408) 839-8359
>> roysrealty.com
>>
>
>
> --
> "Thinking is the hardest work there is. That's why so few people undertake
> it." - Henry Ford
> Bill Pugh
> 1957 TR3
> "Casper"
> TS16765L
> Wallace, CA
>
--
Sujit Roy, Realtor
Keller Williams Realty, Cupertino, CA
(408) 839-8359
roysrealty.com
|