RE: starter bezel. I was basing my comments on a very grainy image in the
TR3 Practical Hints... Looking closer at SPC Plate AD; it appears that you
are correct. That does make my life easier as I now have sufficient beveled
bezels.
Note: that the image Randall provided is for an early push/pull panel
switch.
Thanks
Carl
-----Original Message-----
From: Randall [mailto:tr3driver@ca.rr.com]
Sent: Wednesday, June 29, 2011 2:26 PM
To: cfmtr3a@verizon.net; triumphs@autox.team.net
Subject: RE: [TR] FW: Wiper/Panel Switch Placement TR3
> All bezels on the center console should be
> the beveled (inverted v) bezel which resembles those on the gauges -
> with the exception of the ignition switch.
Unless it was different on the later cars, the bezel for the starter push
button is unique as well. Similar to the one for the ignition switch, but
smaller.
I believe this one is original:
http://tinyurl.com/3cg2cd7
-- Randall
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|