----- Forwarded Message -----
From: suhringtr36 at comcast.net
To: "Alex" <ambritts at bellsouth.net>
Sent: Sunday, May 22, 2011 9:49:06 PM
Subject: Re: [TR] Dzuz Aluminum Bonnet Grommet
Alex:
I tried the way the instructions showed and there was no way I was going to use
two hammers with the likelyhood to damaging the hood. I ended up using a deep
c-clam and two sockets, one that fits the top piece without it touching the
hiood and the other for the engie bay side that is slightly larger than the
post so it pushes in on the washer until it catches the grove.
Scott
----- Original Message -----
From: "Alex" <ambritts at bellsouth.net>
To: "*Triumphs List" <triumphs at autox.team.net>
Sent: Friday, May 20, 2011 4:57:15 PM
Subject: [TR] Dzuz Aluminum Bonnet Grommet
Need to install the aluminum grommet for the dzuz fastener on the bonnet. What
is the correct way to flare the grommet under the hood to lock it in?
?
Also, what is the best way to lock the washer to the fastener?
TIA,
Alex Manzo
59TR3A
triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/triumphs/suhringtr36 at
comcast.net
Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|